Installing LED tube lamps is a wonderful solution to save lots of money on electricity and get potentially risky fluorescent lights from your house or office. However, most LED tube lamps available on the market today cannot just be immediately installed in an existing fluorescent fixture. You will have to make some basic modifications to the fixture to properly install the bulbs. Fortunately that installing an LED tube light in a existing fluorescent fixture is comparatively simple. Furthermore, you should be able to purchase accessories specially created for LED tube lamps in the near future, and they should actually be cheaper compared to the identical fluorescent accessories. This post will provide a short summary explaining what you need to understand to be able to install the new energy-saving fluorescent tube lamps in an existing fluorescent lighting fixture.
Fluorescent fixtures are designed to help a particular kinds and size of fluorescent tube. A fluorescent tube is integrated in to a fluorescent lighting program which contains two or three principal components: (1) the fluorescent lamp (fluorescent lamp or tube), (2) the ballast, and (3) the starter program. In addition, the device for a pipe lamp includes a lamp holder and a switch. Depending on the particular fluorescent lighting program, the beginner may be a replaceable part, a starter may not be needed, or the starter function may be incorporated in to the ballast. The beginning function may also count on the physical layout of the fixture. To retrofit a fluorescent light fixture to assistance an LED tube light, the ballast (and the beginner if a different one occurs) must be disconnected.
Ensure that the LED replacement tube lamps are the correct size for your fixture. Also, remember that when servicing a fluorescent fixture or lamp for any purpose, electric power to the entire fixture should be disconnected. This isn’t always sensible in scenarios where a large number of fixtures are controlled from the same energy control (such as in open office areas). In these cases, insulating gloves and a nonmetallic ladder should be utilized if the accessories must be maintained when electricity is present.
You will need a few simple tools, including a wire cutter and wire stripper (often included in to the same tool), a couple of pliers, a screwdriver, and a few wire nuts for reconnecting the wires once you have removed the ballast.
Once the old bulbs are removed from the lamp cases and the electricity to the fixture is turned off, you will likely have to eliminate the reflector that is located behind the bulbs and offers a home for the cabling and ballast that lay behind it.
For great deals on LED Tubes visit us at http://www.novelenergylighting.com