Cutting down a tree can be a challenge so it is important to have a clear understanding of what steps should be taken. Professionals have safety requirements and it is an excellent idea for home users to take note of these. Since users will be cutting the tree with a chainsaw, protective gear is important to guard against flying pieces. Professionals are required to use head protection, eye and face protection, as well as gear to guard their hearing and bodies. Ideas for the home user include protective chaps and ear plugs. Proper preparation will guarantee safety and an effective process for felling the tree.
It is important to aim for a clear path on which the tree can fall. If there is uneven ground or large rocks, it is not a good idea to cut a tree down in that direction. One of the most important steps is analyzing the best direction in which to cut down the tree. When users find a clear path, it guarantees minimal damage to the tree and avoids throw back, which is when parts of the tree get launched in the direction of the tree cutter. Once a proper path has been determined, users can cut the first notch.
The initial cut or notch is made by creating a top and bottom cut. This releases a wedge from the tree and should be faced in the direction in which the tree will fall. Starting at the side of the tree makes it easier to create the notch. To make the top cut of the notch, start at any level as long as there is room for a bottom cut. The top cut should be made at a downward angle and should stop once ¼ to 1/3 of the tree’s diameter is cut. The bottom cut should begin at a level that allows a 70 degree angle notch opening. The user should cut upward at about a 20 degree angle.
The user should stop when the bottom cut connects with the end point of the top cut. After removing the notch of wood, the next step is in creating a back cut. This cut will be located on the opposite side from the notch. This cut disconnects nearly the whole tree from the stump. It creates a hinge that allows the user to control the direction of the tree’s fall. The back-cut should begin on the other side of the tree, level with the inside point of the notch. The user should cut flat and horizontally. It is a good idea for new users to pause and see where they are at during the cut. The user should stop cutting when there is 2 inches remaining between the back-cut and notch.
The best direction for users to back away is 45 degrees from the sides and back of the tree. Users should never back away directly behind a tree in case of a flying tree butt. Being 20 feet away is a good idea and new users should never turn their back on the tree that is falling. It is also a good practice to stand behind an upright tree for protection when tree cutting. If you are based in Las Vegas, NV, you should visit the following website:
This article is copyright free.